Operating instructions:
1. Start the motor, check whether the operation is normal, check the diameter of rubber and plastic cable in each gear when feeding, feed one by one.
2. In order to make the blade durable for a int time, the connector of rubber and plastic cable should be cut off when feeding to avoid blade chipping.
3. If the feed is too deep and broken after coming out, pay attention to the following conditions:
① Adjust the tightness of the pressure of the M12 screws on both sides of the blade shaft;
② Check whether the position is wrong during feeding;
③ Whether the blade is new or not, and whether the edge is too sharp, the special oilstone should be used to slightly trim until it is moderate.
4. If after feeding, the rubber and plastic have been stripped, but the copper wire can not be spit out.
There are mainly four situations
① If the knurling of the upper shaft is too deep, the special oilstone should be used to grind the upper shaft, but not too much. Too much grinding is easy to cause the transmission of oily cable;
② If the spring pressure is too loose, the pressure should be adjusted tightly to stop when it can be vomited;
③ If the wire diameter is too small or the gap between the upper and lower shafts is too large, the gap between the two shafts should be adjusted to 0.4-0.6mm;
④ The processed rubber and plastic cable has been heated, so the copper wire can not be spit out.
5. If the cable cannot be driven by the pressure gear after feeding and the material stays in the middle, the following situations will occur:
① Check whether the belt of each gear is loose;
② Check whether the spring pressure on both sides of each gear is too tight and there is no jacking force, so the pressure should be relaxed;
③ There is too much oil in the cable, which makes the two shafts slip, so the two shafts should be dried frequently (when drying, if the machine is running, please pay attention to safety);
报错 笔记
|
技术参数（TXECHNICAL PARAMETER）
|
|
型号
|
Model
|
918-B型（大机）
|
|
加工范围：
|
Processing diameter
|
Φ1.5mm---Φ98mm
|
|
机器尺寸：长X宽X厚
|
Overall dimension(LxWxH)
|
77*55*118cm
|
|
机器重量：
|
Machine weight
|
240kg
|
|
电机功率：
|
Motor Power
|
3-4Kw
|
|
10小时/产量：
|
10H/Production
|
500-5000kg
|
中文
English